Guys looking for a wee bit of advice, at a Swiftflow today took a Telegan and got 0.0124 after doing the following, cleaned heat exchanger, inspected burner for cracks, Burner pressures set up correctly, inner flue appears ok, fan running fine. Been working on these boilers for years and never had this problem, going back Monday with a new burner. Anybody had probs b4 with these??
Swiftflow 100e Failing Emissions
- Thread starter BigGBo
- Start date
wash fan impellor, fan gasket, ?
Sounds like you've covered most things. I'd check the burner pressure AND the gas rate just to negate the Gas train. Is the flame pic ok? with most cases I find spiders webs in the air intake part of the flue cause this a lot, cover off and vacuum. Also found that whee the fan enters the flue it is possible that the gasket is not in correctly or has perished, try some silicon sealant first. If combustion case seal is not secure,high readings can be found. Interested to know the outcome m8.
Good luck
Good luck
You can just never tell can you?
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
