Hi all
Just got myself a v3+ stater kit to replace my honeywell thermostat and Honeywell ST699 programmer.
Before I replace the programmer, I noticed a couple extra wires in the existing connections so wanted to ask if I can just go ahead and reconnect the existing wires directly into the same connection on the tado programmer?
I can see that the HW COM loops to the CH COM which loops to the L, but there's also another brown wire in the HW COM which I'm not sure what for. Also have 2 wires in the N connection and not sure where the extra wire is going.
Can I just replace these all into the same slot in the tado and it should work as expected?
Thanks
Just got myself a v3+ stater kit to replace my honeywell thermostat and Honeywell ST699 programmer.
Before I replace the programmer, I noticed a couple extra wires in the existing connections so wanted to ask if I can just go ahead and reconnect the existing wires directly into the same connection on the tado programmer?
I can see that the HW COM loops to the CH COM which loops to the L, but there's also another brown wire in the HW COM which I'm not sure what for. Also have 2 wires in the N connection and not sure where the extra wire is going.
Can I just replace these all into the same slot in the tado and it should work as expected?
Thanks