following on from an earlier thread,
I would like to be able to tile over the floor area,having laid heating cable and probe,but unfortunately the controller/thermostat was damaged,so have been unable to check that the cable is ok.and will be some time before i receive the replacement
I have confirmed that the resistance is within the manufactures spec, is this enough to assure me that the cable is ok..not damaged,or is there a way to confirm that the cable is operating ok with out the controller
I would like to be able to tile over the floor area,having laid heating cable and probe,but unfortunately the controller/thermostat was damaged,so have been unable to check that the cable is ok.and will be some time before i receive the replacement
I have confirmed that the resistance is within the manufactures spec, is this enough to assure me that the cable is ok..not damaged,or is there a way to confirm that the cable is operating ok with out the controller