hi
i'm renovating my 80's dormer and installing the hardware below, i've ran all the cabling and installed the pirs (in all completed rooms), keypads, control panel, smartcom and wireless expander..
The bellbox wires are in place awaiting me renovating the last upstairs room (need access to the rear of each).
I've had power on briefly and everything appears to power on.
Hardware list:
Texecom Premier elite 24 metal case
x2 Texecom odyssey 3 powered backlit external sounder
x 2 premier elite keypads
x8 bosch blueline pet pir
8XE wireless expander
smartcom
x2 smartkey
x3 impaq w sensors
also plan to add garage door sensors x2 at a later date.
i think i understand the EOL wiring and have mocked up what i think the connections are meant to be at the pir, can anybody clarify this is right? As per this helpful thread on here https://www.diynot.com/diy/threads/texecom-premier-elite-24-wiring.501897/
i've set them as:
4k7 across the Alarm NC terminals
2k2 from NC terminal to Tamper.
Wire 1 into NC with the 4k7 leg.
Wire 2 into unused Tamper Terminal.
and then all is required to complete the PIR install is to connect the zones in the panel up as below and ensure the settings are configured to use eol, is that right?
heres a wider shot to show how i've set it up.
Plan is to get all the wired bits working fist then add/setup all the wireless expander, impaqs, smartcom and smartkeys.
i'm hoping to operate the electric garage door with the smartkeys.
any other advice or suggestions welcome
i'm renovating my 80's dormer and installing the hardware below, i've ran all the cabling and installed the pirs (in all completed rooms), keypads, control panel, smartcom and wireless expander..
The bellbox wires are in place awaiting me renovating the last upstairs room (need access to the rear of each).
I've had power on briefly and everything appears to power on.
Hardware list:
Texecom Premier elite 24 metal case
x2 Texecom odyssey 3 powered backlit external sounder
x 2 premier elite keypads
x8 bosch blueline pet pir
8XE wireless expander
smartcom
x2 smartkey
x3 impaq w sensors
also plan to add garage door sensors x2 at a later date.
i think i understand the EOL wiring and have mocked up what i think the connections are meant to be at the pir, can anybody clarify this is right? As per this helpful thread on here https://www.diynot.com/diy/threads/texecom-premier-elite-24-wiring.501897/
i've set them as:
4k7 across the Alarm NC terminals
2k2 from NC terminal to Tamper.
Wire 1 into NC with the 4k7 leg.
Wire 2 into unused Tamper Terminal.
and then all is required to complete the PIR install is to connect the zones in the panel up as below and ensure the settings are configured to use eol, is that right?
heres a wider shot to show how i've set it up.
Plan is to get all the wired bits working fist then add/setup all the wireless expander, impaqs, smartcom and smartkeys.
i'm hoping to operate the electric garage door with the smartkeys.
any other advice or suggestions welcome