+1 for the Inceptor Micro, I got some a while back. Seem to remember the cutout dimension is specified as 65mm, I tried this and couldn't get the light to fit into the hole (cable comes off the side at the top IIRC which makes it larger than 65mm).
Tiltable down lights needed, advice please
- Thread starter r1flyguy
- Start date
Sponsored Links
The cut out size is given as 65-75mm. It does rather depend on the thickness of the ceiling. I usually do them at 70mm, you can damage the hole, if they are too tight.
The cut out size is given as 65-75mm. It does rather depend on the thickness of the ceiling. I usually do them at 70mm, you can damage the hole, if they are too tight.
Awesome movie
&
Ordered the micro's
Ordered the micro's
Sponsored Links
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
