I have used a Yorkshire elbow in a tight spot and it has failed so i need to redo.
I have removed the elbow but obviously the pipe ends still have solder on them.
So i presume the ends are both classed as being "tinned", yes ?
If so, what's the the steps to try another elbow, just clean with wirewool the pipe ends and the inside of the elbow, flux both pipes and inside of elbow as normal ?
Also, can i use another Yorkshire ?
I have removed the elbow but obviously the pipe ends still have solder on them.
So i presume the ends are both classed as being "tinned", yes ?
If so, what's the the steps to try another elbow, just clean with wirewool the pipe ends and the inside of the elbow, flux both pipes and inside of elbow as normal ?
Also, can i use another Yorkshire ?