Toilet system not filling

Joined
18 Nov 2026
Messages
8
Reaction score
2
Country
United Kingdom
My toilet system is not filling, just keeps running through into toilet, I've stuck a pen in it for now as the continuos noise of running water is driving me nuts!
Advice very welcome! I've attached phThank you
 
If water keeps running into the pan and the cistern never fills, it's almost always the flush valve seal (the big rubber washer at the bottom of the flush mechanism) not sealing any more. The pen holding the float up just stops the fill valve, so it's a fine stopgap.
Quick way to tell which part it is: take the lid off and look at the water level.
  • Level below the top of the overflow tube but water still trickling into the pan = flush valve washer leaking. Turn the water off at the isolating valve on the feed pipe (slot screw, quarter turn), flush, then most modern push-button valves twist or unclip out of the base. Take the old washer to Screwfix or Toolstation to match it. It's a few quid.
  • Level up to the top of the overflow and spilling into it = the fill valve isn't shutting off. Adjust the float lower, or replace the fill valve washer or the whole valve.
Limescale or a bit of grit on the seal can do it too, so give the seat a wipe while it's apart.
 
Back
Top