upgrading control panel, bell box wiring

[mayurw]

Hi guys

I'm helping out my uncle replacing an ageing ADE Optima with a Scantronic 9651 panel. Now I'm not sure what brand the bell box is but I have noted the following 5 wires connected on the ADE panel;

Strobe -
T
A
Bell +
Bell -

so how do I transfer these onto the Scantronic?

 

[oasistechnical]

+ ve 12v to 12volt aux
- ve 12v to 0 volt aux
tamper to TR
siren trig to OP1
strobe trig to OP2

its that easy

Oasis

 

[mayurw]

Thank you Oasis for your prompt reply. Just to be sure, is the below correct?

ADE to Scantronic

Bell + to 12volt aux
Bell - to 0 volt aux
T to TR
A to OP1
strobe (-ve) to OP2