I'm converting our unused passageway in to a utility room, however the issue is the room is only 950mm wide at this point and I can't move it anywhere else due to the slope form the stairs and the washer and dryer already being in place.
Originally I was going to fit a steel sink with drainer but its 850mm wide and I'm concerned this is too wide on side a narrow section of worktop. Will this work or would I be better getting a sink with no draining board so its only around 600m wide?
Originally I was going to fit a steel sink with drainer but its 850mm wide and I'm concerned this is too wide on side a narrow section of worktop. Will this work or would I be better getting a sink with no draining board so its only around 600m wide?
