Utility room sink

craigap · 2026-09-25T16:50:38+0100

I'm converting our unused passageway in to a utility room, however the issue is the room is only 950mm wide at this point and I can't move it anywhere else due to the slope form the stairs and the washer and dryer already being in place.
Originally I was going to fit a steel sink with drainer but its 850mm wide and I'm concerned this is too wide on side a narrow section of worktop. Will this work or would I be better getting a sink with no draining board so its only around 600m wide?

Wayners · 2026-09-25T20:18:15+0100

Not my area of knowledge but I think I understand what you are saying.

If you fit a inset sink.
800mm sink in 950mm worktop set on 900mm cabinet with fill panels either side or one side?

diynot

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

Utility room sink

craigap

Wayners

DIYnot Local

Similar threads