- Joined
- 23 May 2024
- Messages
- 1
- Reaction score
- 0
- Country
Hello
I have a technical question about the "3-way motorized valve". In the "hot water only" setting, the motor pin should be fully extended (which will push the pin in the valve in), fully inserted into the motor (which will pull the pin out of the valve towards me), or in the middle. I'm not sure if I have the correct signal to the motor.
I have a technical question about the "3-way motorized valve". In the "hot water only" setting, the motor pin should be fully extended (which will push the pin in the valve in), fully inserted into the motor (which will pull the pin out of the valve towards me), or in the middle. I'm not sure if I have the correct signal to the motor.
