Veritas r8 re-siting panel

[houstonwehaveaproblem]

Hi

I need to re-site my control panel so need to remove power while doing so.

I guess the bell box will activate when I do this.

I have the engineers codes. Is there a way to ‘hold off’ the bell or similar while doing the panel move?

 

[sparkymarka]

Depends on bellbox ...but if not put the battery on the the bell supply

 

[houstonwehaveaproblem]

Depends on bellbox ...but if not put the battery on the the bell supply

Thanks

it’s a Texecom Oddysey X3

 

[secureiam]

if the strobe is connected you can place the bell into hold off mode, cnt remember the exact instructions for doing so on the veritas but its strobe on off about 3 times i think and then the comfort leds will indicate its in hold of mode. On a premier in bell test just press omit and it takes care ofit but ages since I have done one on a veritas

 

[houstonwehaveaproblem]

Thanks

if the strobe is connected you can place the bell into hold off mode, cnt remember the exact instructions for doing so on the veritas but its strobe on off about 3 times i think and then the comfort leds will indicate its in hold of mode. On a premier in bell test just press omit and it takes care ofit but ages since I have done one on a veritas