Help!
I turned on my heating in sept for a day or so and it worked fine. I then recently turned it back on and now the downstairs hallway and living room rads are not working (stone cold) so I have bled each radiator and now the boiler (which is in the kitchen) cuts out when you turn the heating on. It didn't previously. I have altered the pressure so it is between 1-1.5 (went from low to too my making it too high so bought it back down by bleeding radiator again).
I think I should add that I he had problems with these two rads before and as a result had the system power flushed in June, am now wondering if it was not flushed properly?
Any suggestions comments would be greatly received!
UPDATE: As of this morning neither the heating or the hot water works, the boiler cuts out when you try to put either on (LED light turns red).
I turned on my heating in sept for a day or so and it worked fine. I then recently turned it back on and now the downstairs hallway and living room rads are not working (stone cold) so I have bled each radiator and now the boiler (which is in the kitchen) cuts out when you turn the heating on. It didn't previously. I have altered the pressure so it is between 1-1.5 (went from low to too my making it too high so bought it back down by bleeding radiator again).
I think I should add that I he had problems with these two rads before and as a result had the system power flushed in June, am now wondering if it was not flushed properly?
Any suggestions comments would be greatly received!
UPDATE: As of this morning neither the heating or the hot water works, the boiler cuts out when you try to put either on (LED light turns red).
