Volker boiler post-flush
- Thread starter dom64
- Start date
01 is failure to ignite so is unlikely to be related to the powerflushing unless they knocked a wire off the gas valve or spark electrode.
Looking at stuff like gas valve, gas pressure, ignition components.
A bit more info would be helpful.
Did they flush from the pump within the boiler?
What model is it?
Looking at stuff like gas valve, gas pressure, ignition components.
A bit more info would be helpful.
Did they flush from the pump within the boiler?
What model is it?
The Linea had a problem with the plastic shaft of the middle selecor nob. Check you don't just need a new nob. I bought a pcb needlessly before I discovered this.
I should add, I was getting fault code 01 followed flow chart, at end it said "is ignition pcb OK" answer, YES? new main pcb.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
