I need to purchase and install a wash basin vanity unit. There is a 40mm waste pipe running horizontally along the wall at floor level (discharge from shower).
Are (all/any) vanity units designed such that a small section can be cut from the rear of the two sides to allow the waste pipe to pass along the back and also allow for a 'T' joint to accommodate the waste from the basin?
The pipe would be boxed in both sides of the unit thus hiding the cuts B
Are (all/any) vanity units designed such that a small section can be cut from the rear of the two sides to allow the waste pipe to pass along the back and also allow for a 'T' joint to accommodate the waste from the basin?
The pipe would be boxed in both sides of the unit thus hiding the cuts B