• Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.

Where is the mesh filter on this inlet control group?

EmmeG said:
Hi, can anyone pls clarify what is meant by "depressurise everything" before I can open the inlet control set to clean the mesh filter? I have closed the cold mains, would that be sufficient or is it anything else required?

Similarly, I want to check that the pressure of the expansion vessel is 3 bar as recommended by the manufacturer (Tribune). Is it really just a matter of unscrewing the cap of the schrader valve and connecting a pump to it and adjust as necessary? Any step required or advisable before I do that?

Many thanks.
Click to expand...

Start a new thread and you may get some answers.
 
Also, if this is for an unvented cylinder then working on the inlet control group isn’t really DIY territory, these pieces of equipment are regulated for good reason.
 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
You must log in or register to reply here.

Similar threads

J
Taps - Wire mesh filters
Replies
1
Views
3K
JB.™
J
D
Unvented System hammering noise
Replies
8
Views
1K
David2749
D
A
Mixer shower without the inlet filters?
Replies
2
Views
8K
martinclukey
M
D
miele W844 check input warning light flashing
Replies
1
Views
2K
dorfl
D
S
Magnetic Filter Problem
Replies
8
Views
5K
Sonic70
S
Back
Top