Whirlpool DWH B10 dishwasher, 11 flashes

[EvilDMP]

My Whirlpool DWH B10 dishwasher starts its cycle, begins to fill with water, but after some seconds beeps (11 flashes) and drains.

It's spotlessly clean inside.

The pressure sensor switch and diaphram - the usual culprit when there's an 11-flash error - move freely. I have dismantled and cleaned them anyway, and tested the switch operation with a continuity tester: all OK.

There are no leaks anywhere, and machine fills and drains swiftly. All the pipes are pretty clean and unblocked.

Any other suggestions?

Thanks.

 

[yardie]

Anti flood switch?

The switch you tested, is it a one way or 2 way switch? I.e 2 wire or 3 wire?

 

[EvilDMP]

My Whirlpool DWH B10 dishwasher starts its cycle, begins to fill with water, but after some seconds beeps (11 flashes) and drains.

It's spotlessly clean inside.

The pressure sensor switch and diaphram - the usual culprit when there's an 11-flash error - move freely. I have dismantled and cleaned them anyway, and tested the switch operation with a continuity tester: all OK.

There are no leaks anywhere, and machine fills and drains swiftly. All the pipes are pretty clean and unblocked.

Found it - it was a break in one of the wires coming from the pressure switch to the control panel, leaving the circuit open, at the point where the wires come under the door and up to the control panel.