Whole Of House Water Softener

Joined
9 Dec 2009
Messages
170
Reaction score
0
Location
West Midlands
Country
United Kingdom
Hi,

Looking for a whole of house water softener.
Water Hardness: 292 ppm

Reading older threads I have seen Kinetico & Monarch mentioned.
I would be grateful for opinions & experience on these or others you may be using.
Especially if there is an impact on pressure drop. The taste of the water doesn't seem to be an issue as most water softeners quote 200mg/L of water

I have a 300L Unistor valiant Unvented cylinder, 2 showers & bath. I have space to put the water softener right next to mains supply. I have a power supply available if needed.

Appreciate your time.

Thanks

Jass
 
The taste of the water doesn't seem to be an issue as most water softeners quote 200mg/L of water

It sounds like you are under the misapprehension that softeners add salt to the water.

They don't.

The softener can be positioned anywhere you want, but remember you will be accessing it regularly to put sacks (or blocks, at higher cost) of salt into it, so you want it to be quite near an entrance door.

Mine holds about 50kg of salt. I used to get 20kg bags delivered twice a year. Now I have 10kg bags that are easier to carry.

Do not carry salt in your own car. A single spilled grain can eat a hole in the steel. Look inside the salt delivery van and you will be shocked at the rust.

When choosing your supplier, your first question is "do you repair water softeners." If the answer is no, find another supplier. Some will only repair softeners they have supplied. Some may offer their own make, the parts are very simple and easy to assemble. The only working part is the control valve, which IME needs service after 10 to 20 years when the rubber sealing rings wear out. I have had several, and recommend the Fleck control valve, which is an international standard, used by many manufacturers, parts are widely available, easy to service and repair. Cheap softeners are available from the DIY sheds which can be viewed as throw-away. If you look at some photos online you will easily recognise the valve when you see one.

You will need large-bore valves and hoses, which cost a little more than the 15mm ones if bought with the machine, but much more if retro-fitted.
 
Last edited:

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top