I bought a lot of Wickes Torus pine skirting board a good while ago. I was planning to fit it a soon as I bought it but because of numerous reasons I've only recently had time to get round to it. It has been stored flat and in my house since.
My problem is that every single piece of skirting seems to bow slightly when looking at the profile of the wood. I put his down to just one of the pieces being 'off' but every single piece is the same. Not just similar either, every piece seems to have exactly the same amount of bend. Is this just an (expensive) coincidence or is the Wickes Torus moulded to this shape for some reason that I'm missing?
Needless to say its making mitering the external corners around the chimney breast impossible.
My problem is that every single piece of skirting seems to bow slightly when looking at the profile of the wood. I put his down to just one of the pieces being 'off' but every single piece is the same. Not just similar either, every piece seems to have exactly the same amount of bend. Is this just an (expensive) coincidence or is the Wickes Torus moulded to this shape for some reason that I'm missing?
Needless to say its making mitering the external corners around the chimney breast impossible.