Hello,
I'm in the process of changing all my radiators which are supplied by pipes which come out horizontally from the wall. I need to add a drain off valve to each radiator as they are drop fed from upstairs.
I've seen this https://www.screwfix.com/p/drayton-...gclsrc=aw.ds&dclid=CO7KwZnC3NgCFY0TGwodxFYA_Q
tail piece from Drayton. Unfortunately if you use a non-Drayton TRV (they don't do any angled versions), the thread on the valve side does not fully screw into other makes lockshield valves.
Before I order a job lot and start fitting them, is it likely to seal properly?
I'm in the process of changing all my radiators which are supplied by pipes which come out horizontally from the wall. I need to add a drain off valve to each radiator as they are drop fed from upstairs.
I've seen this https://www.screwfix.com/p/drayton-...gclsrc=aw.ds&dclid=CO7KwZnC3NgCFY0TGwodxFYA_Q
tail piece from Drayton. Unfortunately if you use a non-Drayton TRV (they don't do any angled versions), the thread on the valve side does not fully screw into other makes lockshield valves.
Before I order a job lot and start fitting them, is it likely to seal properly?