See on the photo below where it connects to the cylinder.
The side which goes through the wall (left side) then I cannot follow where it goes. The other side you can see it in the photo below.
Hi there, I have the same Vokera heating system with the timer and an old thermostat and I got a Heatmiser RC1 WTS wireless thermostat. I was wondering if anyone can confirm the connections I need to make please, I got two pictures , thank you.
It's not just the boiler that makes up a system, that's the simple bit electrically speaking, it's the controls that are connected that determine the wiring.
Unfortunately you don't give us a lot to go on. However, if this is just a thermostat swap, if you can provide us with the details of the existing thermostat and the wires that presently go to each terminal, we should be able to work out what each one does and where they should go on the new thermostat.
I may be off line for a while now, but if you post the information someone else may get to it before I do and be able to help.
BTW. It's usually best to create a new thread rather than tack a new question on to an existing one. Not only are you more likely that it will be read (no need to scroll down 4 pages to get to your post) it's also known as hijacking and is against the rules, but because you are a newbie, I'm sure everyone will be kind to you.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local