Hi all
stumbled on this great site whilst trying to find a solution to my following problem:
I noticed a few weeks ago that my pressure gauge was reading 3bar so i got the manual out and drained off the system until it read 1 bar then re-filled to just below 1.5 bar. All seemed well. A few days later i noticed that the hall rad was cold despite heating being on, i checked all the others and all my rads were cold to the touch. Checking hte boiler again revealed that the pressure gauge was reading zero. So i re-filled the system again to 1.5 bar and checked the rads for air and two needed bleeding. All seemed well again but tonight the gauge is showing 3 bar again??? any other experience of this or any ideas would be great please
many thanks in advance
Baz
stumbled on this great site whilst trying to find a solution to my following problem:
I noticed a few weeks ago that my pressure gauge was reading 3bar so i got the manual out and drained off the system until it read 1 bar then re-filled to just below 1.5 bar. All seemed well. A few days later i noticed that the hall rad was cold despite heating being on, i checked all the others and all my rads were cold to the touch. Checking hte boiler again revealed that the pressure gauge was reading zero. So i re-filled the system again to 1.5 bar and checked the rads for air and two needed bleeding. All seemed well again but tonight the gauge is showing 3 bar again??? any other experience of this or any ideas would be great please
many thanks in advance
Baz