has anyone fitted these? They are like mini worktops but attach to make a small 90 deg. splashback. So the worktop has an angle at the back. When fitting is it just a case of gripfilling to wall and then silicon seal the corner? Advice appreciated. 
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Worktop upstand splash back thingy
- Thread starter Mr Ben
- Start date
Yes, just a decent size bead about 15mm inside the edges. After re- reading your post, I realised you are using the small one, so no sockets to cut around.
You could put a bead along the bottom or one on the front of the joint after it has dried to the wall.
You could put a bead along the bottom or one on the front of the joint after it has dried to the wall.
thanks Fitter that's great!
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local