Zanussi E20 error WJD 1257 S

[Mat-Moo]

Hello all

I've had this washer/drier for around 4 years. A couple of years ago it started not draining and giving constant e20 error, so did some research and fitted a new drain pump, and hey presto, all was good (old one was getting noisey before it gave up!).

Anyhow, here I am now with E20 errors again, however it is doing the wash / spin / drain with no problems, no noises and everything looks good. But when it starts the DRY cycle, it runs for about 2 mins - the blower motor starts, the heater matrix part feels warm, then just stops with E20? Any clues/Ideas welcome before I have to empty my savings into an engineer

 

[Mat-Moo]

Guess I'll have to call an engineer

 

[Sleepyhead]

E20 is a generic fault code displayed to the user. The engineer can enter diagnostics mode and get a further fault code. This tells him where the fault is likely to be.