Hi,
I am looking at getting a Zinc roof installed pdq. Timber is up, 18mm marine ply @ 3° pitch. The 'flat' part of the roof adjoins the front pitched part (slate), I am sure this is a pretty simple install. The flat roof is about 2.8m x 3m and has a parapet wall either side to flash into and the main house gable to flash into at the back.
Can anyone advise on any good contractors to quote for this job in Warwickshire? Also, what is the typical cost per sq m for fitted Zinc (looking at VM Zinc)?
Thanks,
Bill
I am looking at getting a Zinc roof installed pdq. Timber is up, 18mm marine ply @ 3° pitch. The 'flat' part of the roof adjoins the front pitched part (slate), I am sure this is a pretty simple install. The flat roof is about 2.8m x 3m and has a parapet wall either side to flash into and the main house gable to flash into at the back.
Can anyone advise on any good contractors to quote for this job in Warwickshire? Also, what is the typical cost per sq m for fitted Zinc (looking at VM Zinc)?
Thanks,
Bill
