As the title says I have an Accenta G4 panel and trying to connect my ADT (Elmdene) bellbox to it.
Just fitted it all and all working fine apart from this problem.
When I go to first power up the alarm and enter my code it silences the rkps but the adt bellbox carries on with the siren.
There are no error messages on the rkp.
I have wired the bellbox to my panel as follows:
H+ to panel D Bell+
R- to panel B Bell -
ENG not connected
ST- to panel Strobe -
Batt. There is a blck wire connected that back inside the adt unit.
The following terminals are wire linked together in the panel:
H- to panel A SCB
RTN to panel T SCB
Please help me
Just fitted it all and all working fine apart from this problem.
When I go to first power up the alarm and enter my code it silences the rkps but the adt bellbox carries on with the siren.
There are no error messages on the rkp.
I have wired the bellbox to my panel as follows:
H+ to panel D Bell+
R- to panel B Bell -
ENG not connected
ST- to panel Strobe -
Batt. There is a blck wire connected that back inside the adt unit.
The following terminals are wire linked together in the panel:
H- to panel A SCB
RTN to panel T SCB
Please help me