Hi all,
After much thought and advice received on this forum, I purchased a Texecom 24 with expander to replace my trusty old Securit 700l.
I wired everything up yesterday and did a little programming all the PIRs door contacts and PA's work on a walk test and all zones are secure under engineer utils.
I have not tried to arm it yet
a few things i could use a hand with please.
1, the Green LED in the Panel is flashing, manual says AC power fault but thats not it.
2, how do i get rid of the reset service messages that show up. Call Alarm co, Call engineer to reset system, call ARc etc.
3, It reports I have a tamper on the RKP, not sure how this is possible when the lid is on.
Many thanks
After much thought and advice received on this forum, I purchased a Texecom 24 with expander to replace my trusty old Securit 700l.
I wired everything up yesterday and did a little programming all the PIRs door contacts and PA's work on a walk test and all zones are secure under engineer utils.
I have not tried to arm it yet
a few things i could use a hand with please.
1, the Green LED in the Panel is flashing, manual says AC power fault but thats not it.
2, how do i get rid of the reset service messages that show up. Call Alarm co, Call engineer to reset system, call ARc etc.
3, It reports I have a tamper on the RKP, not sure how this is possible when the lid is on.
Many thanks