Got new single phase electric motor, diagrams and all.
But i'm an architecturally minded engineer and don't know squat about electric diagrams.
Its a 1.1kw single phase Etec ML8022. I just need to know how to wire mains cord to it.
Here's whats in control box:
and here's the diagram on the lid:
Notice there are two stripped multicores sticking out from V2 and U2. I assume its where live goes, but what about ground (green/yellow)? Its bolted into motor body and there are no visible/spare external ground wires etc...
Can someone help me figure this one out ?
Also, could someone help me wire in external direction switch for it, as it goes both ways and i may need to go in reverse...
But i'm an architecturally minded engineer and don't know squat about electric diagrams.
Its a 1.1kw single phase Etec ML8022. I just need to know how to wire mains cord to it.
Here's whats in control box:
and here's the diagram on the lid:
Notice there are two stripped multicores sticking out from V2 and U2. I assume its where live goes, but what about ground (green/yellow)? Its bolted into motor body and there are no visible/spare external ground wires etc...
Can someone help me figure this one out ?
Also, could someone help me wire in external direction switch for it, as it goes both ways and i may need to go in reverse...