Hi,
As title, and I'm positive it was far better last year...
So I've had the CH on all day, set to manual and with a target temp of 20degC. It's currently 18degC in the room that I have the thermostat in and has been for ages. The controller (Center 7 day programmable) has the flame indicator on, but has done all day. I went and watched the boiler to see if it was genuinely on, and it was sat at 40degC water temp. I waited and the flame came on and temp went up to 80degC (full) but only for 20-30 seconds and then back down to 40. The hot water seems fine, but again I'm sure it was hotter in the past
Any ideas? For full disclosure the Mrs had a guy come round to check on it and he (apparently) balanced the rads. His suggestion was that he'd run a cleaner through it (£200...) or that the boiler wasn't sufficient to run our ten radiators... Water pressure is fine btw.
Any ideas?
As title, and I'm positive it was far better last year...
So I've had the CH on all day, set to manual and with a target temp of 20degC. It's currently 18degC in the room that I have the thermostat in and has been for ages. The controller (Center 7 day programmable) has the flame indicator on, but has done all day. I went and watched the boiler to see if it was genuinely on, and it was sat at 40degC water temp. I waited and the flame came on and temp went up to 80degC (full) but only for 20-30 seconds and then back down to 40. The hot water seems fine, but again I'm sure it was hotter in the past
Any ideas? For full disclosure the Mrs had a guy come round to check on it and he (apparently) balanced the rads. His suggestion was that he'd run a cleaner through it (£200...) or that the boiler wasn't sufficient to run our ten radiators... Water pressure is fine btw.
Any ideas?