- Joined
- 10 Jul 2019
- Messages
- 5
- Reaction score
- 0
- Country
I've had a nice new worktop just put in but am concerned as it doesn't appear to be joined properly. One is slightly higher than the other plus there is a visible gap between them. I can see in one part it stack very tightly bit then it separated. The difference is noticeable and this is not the finish I was looking for. When I put a credit card on top I can see a gap. The hob was not fitted straight either. It is slightly off and at an angle, which is noticeable. Is there a way to remedy these without the need to purchase another worktop and without the damagee to the existing one? The fitter who did this is someone I know, which makes it awkward.
Attachments
Last edited by a moderator: