- Joined
- 24 Dec 2015
- Messages
- 128
- Reaction score
- 3
- Country
I'm installing a 32A car charger, ahead of a new distribution board being fitted so that it can be hooked up by the electrician.
There's no instructions though....
I'm assuming that live and neutral will go into the circuit breaker and earth into the green and yellow adjacent connector to join the other earth coloured wires.
What I'm surprised about though is no obvious point to bring 6mm cable into the back of the unit, which I thought would have been there with some seal to make watertight. I presume the I need to make a small hole towards the bottom edge of the back, so that if any moisture enters then it can escape without going near the components.
Any thoughts?
Thank you