Cracked and Loose thermalite blocks. How do I fix this?

[mjgreen81]

Hi all,

I'm currently in the middle of a bathroom refurb on my late 1990s house It's my first time attempting a project of this size so I am learning as I go.

I've removed the dot and dab plasterboard from the external wall and I've found quite a large crack and a couple of the blocks under the window are quite loose and feel like I could pull them out if I tried.

I'm not too worried about the crack as from previously reading about these types of blocks, I do know that it is not particularly uncommon as the house moves.

However, I would like to try and repair this as much as possible and certainly try and resecure the loose blocks.

Can I get some advice for the best way to do this please?

Many thanks

 

[foxhole]

Maybe a small crack repair kit.

Professional Masonry Wall Crack Repair Kit – 3 x 380ml High-Strength Structural Resin Cartridges & 5 x 6mm Stainless Steel Helical Bars – Brick, Block & Stone Crack Stitching Repair System : Amazon.co.uk: DIY & Tools

Free delivery and returns on all eligible orders. Shop Professional Masonry Wall Crack Repair Kit – 3 x 380ml High-Strength Structural Resin Cartridges & 5 x 6mm Stainless Steel Helical Bars – Brick, Block & Stone Crack Stitching Repair System.

amzn.eu

 

[Wayners]

Have you watched the skill builder?

Remove blocks and replace if it bothers you

 

[mjgreen81]

Have you watched the skill builder?

Remove blocks and replace if it bothers you

Love this guy, but haven't seen this video. Will give it a watch

 

[noseall]

Pin a sheet of EML over it, then make sure you bridge the crack adequately with the sheet material (plasterboard, aquaboard etc). Plenty of dab on the EML.

You run the risk of cracking the remaining good blocks if you try and remove them. Especially if the compo is good gear. It's doable but you need a few power tools at your disposal to destroy the block from the centre out. We have had to tooth out loads of aerated blocks and it's a gamble.

 

[mjgreen81]

Pin a sheet of EML over it, then make sure you bridge the crack adequately with the sheet material (plasterboard, aquaboard etc). Plenty of dab on the EML.

You run the risk of cracking the remaining good blocks if you try and remove them. Especially if the compo is good gear. It's doable but you need a few power tools at your disposal to destroy the block from the centre out. We have had to tooth out loads of aerated blocks and it's a gamble.

Thanks. What about the ones directly under the window that seem loose already? Should I attempt to re-mortar them?

 

[noseall]

Thanks. What about the ones directly under the window that seem loose already? Should I attempt to re-mortar them?

Drive a slate perp' wedge in - vertically so you don't crack anymore blocks.

 

[mjgreen81]

Drive a slate perp' wedge in - vertically so you don't crack anymore blocks.

As a newbie to this, I'm not too sure what a slate perp wedge is.

Is this just a term for a wedge? I.e.i could just use a plastic packing wedge?