Recent content by Butchybutch

  1. Untitled

    Untitled

  2. Untitled

    Untitled

  3. B

    Need advice on fixing an Ideal Classic boiler

    Not much to go wrong with a Classic! Only the fan to be honest! Is the fan spinning freely ?
  4. B

    Honeywell 3 port valve fully open but no hot water

    Oilhead is right! There will be a wiring fault there, sounds like a few people have had there fingers in it! Download a wiring diagram for a "Y" plan, and check it.
  5. B

    Combi boiler conversion

    You can ask questions on here all day long, everyone will have a different opinion and you will be none the wiser! I have fitted a few 937's not over impressed with them the boiler is huge, and like i said earlier you need a blow off pipe which can be a pain if your fitting it upstairs or...
  6. B

    Combi boiler conversion

    Personally Id leave the pipework alone, your pressure and flow rate is really good, I cant see any benefit in upsizing, like you say the vaillant takes 15mm inlets anyway! You will need 22mm gas to the boiler, and if it was me Id fit an 837, the 937 is a big boy, dont forget you will need a...
  7. Untitled

    Untitled

  8. various

    various

  9. B

    Honeywell CM907 Room Stat wiring..............?

    Heating controls come under part L of the building regulations, a room stat or trv's are required to comply, having said that the installer only fills in the benchmark form that comes with the boiler, this is a record of commissioning and a record of future servicing, this remains your property...
  10. B

    Honeywell CM907 Room Stat wiring..............?

    http://www.honeywell.be/DocsAdobePDF/EN/Chronotherm/CM90X_ig_EN.pdf Try that one :)
  11. B

    New House Thermostat

    Without seeing the one in question its a bit hard to comment, however I would suggest emailing or phoneing the manafacture and asking them! sorry dont mean to rain on your parade! Brian
  12. B

    Vaillant 824E won't ignite - help wanted

    If its clicking then your almost there, I dont want to say to much as this is not the gas forum, but make sure the gas is on and its getting to the boiler! good luck
  13. B

    heating diagram

    It sounds like a "Y" plan with a zone valve installed for further control, if you want to control both valves you will need a 3 channel programmer like a Horstmann. Just for information I have 2 cylinders in my house standing side by side in the loft, the primarys are connected together and...
  14. B

    Wiring Honeywell HC60NG

    The receiver would normally be fitted near to the wiring center for ease as you need a permanent live, as at present your live will come via the programmer, this means that when the heating is off on the programmer then there will be no power to the receiver. TS630B Brown = Live Blue =...
Back
Top