Recent content by Thomasjameshutton

Thanks I will in the morning when I get back to work

The converter is fed from a fused spur that takes it power from the switched live from the bathroom fan so the fan will come on when the light switch is pulled It is a man rose but not sure which one. It is like the one below Many thanks So. The fuse spur is fed from the light...

Good evening, I have a bath room fan that I am having trouble with. It has a 12v converter that has incoming L/N/LS 0v/12v/LS On the fan it has neutral. Permanent luve and then LS normal fans we install just have 12v/0v My question is what is LS AND how would I wire it...

I have a problem with a light fitting. I have put in led lights and the circuit has 2 switches. If I turn it on with switch 1 they turn of fully but if I turn it off with switch 2 the lights stay on a little. But they are still on But with normal lamps, it's fully off with both switches...

This is a Emerson heater at my dad's house he has just got fitted by some plumbers They have plugged twin and earth into a plug top. Shouldn't this be heat resistant flex? It has burn the plug out Or should it go straight into the fuse spur, the fuse spur on the wall used to feed an old...

Hi. Just to answer a question at work. I'm installing a texecom premier 88 at work and the fuse spur is 10 meters from the panel. Is it ok to run the 3 core flex (in conduit) at this length. Texecom say it is ok and they have no limit as long as the is no voltage drop( 230 needed at panel)...

Yes I could do it myself but the wife wants someone in to do it!! It's on the ring main, a socket was replaced for the fuse spur. So there's a 32a mcb on that ring, but the CU Does have an rcd

Hi I have just moved into a new house and there is a spa bath in the that works but it is run of a 13a fuse spur on the outside of the bath room, which I have been told used to be a single socket Now I have bought a rcd fuse spur to replace the existing fuse spur. How much should I be...

Hi Thanks for your time in answering this question. I am studying at college and am stuck on a question I have been asked Successful Zs tests will prove that all earth fault loops have: A) low resistance - enabling disconnection times to be met B) high resistance - enabling...

Ye that's what I though when it said from the us. Thanks anyways

Hi I'm studying towards my lv3 NVQ. and wanting to read as much as possible. Is this book ok for the uk http://www.amazon.co.uk/Electrical-Wiring-Residential-Ray-Mullin/dp/1435498267 Many thanks T-j

Hi pal sorry for the delay been busy. I'm based in doncaster

Yes thank you very much. The sockets are earthed fine. It was just the light switch that was in a connection block as there was no where else to put it. All the other earths were ok

Hi. Long timer looking, first time poster. Quick question, I went to replace a light switch in my work room, as the switch was broke, I opened it up and the earth wire just a had a piece on connection block onto it as the plastic patress has no earth connection. Is this ok? The switch t...

Hi, I have lots of experience with both man guards and cctv so I can give you a bit of information if you want, I have installed cctv for 12 years so know a bit about it. If you want pm me I am happy to help anyone looking for advice