Hi All
I have just had to replace the locking strip on a composite door which was broken and I now realise the other door isn't locking as well as the new one. Im not sure it's the locking strip thats a t fault and it might be the door that needs adjusting. Does anybody know the name of these...
Hi All
We have a Vaillant eco tec 615 now with 14 rads , 3 are new tall big heavy rads. this was ok when it was fitted years ago but is it big enough now for 14 rads in a 5 bed detached.
Thanks
Hi All
I have a Millenco locking bar thats going to need to be replaced in the near future. I have just replaced one on the front door which was a ERA one for £31
is it possible to replace a Millenco locking bar with an ERA locking bar are they swappable or do I has to put a Millenco in again...
Hi All
I have a 10 year old Vaillant eco tec 615 system boiler thats losing pressure, it loses approx 0.1 bar per day so I have to top it up each week. Nothing comes out of the PRV, no loss of water on any rads, no signs of water loss. The heating engineer found on a recent service a valve that...
Hi All
My relief pipe from my storage tank goes outside on the 1st floor and down to the ground, I can see marking/weepage on the pipe. photos attached doe that means I have a problem with the tank ?
Thanks
Hi All
Just had Vaillant ecotec 615 serviced today and a new prv. Just noticed boiler had a F23 temp alarm and said to turn off the boiler. ive turned it off and back on and it's gone away just now, apart from ringing the engineer tomorrow . whats the problem and can I do anything
thanks
HI All
On a Magnaclean air vent is it the square nut in the vent thats supposed to move or the whole round vent as on mine its the whole round vent that moves. When I tighten it back up it feels like its going tight then loose again. Should I replace it ?
I had a radiator replaced a few days ago and now I hear gurgling through the Magna Clean like water going through it , is this air in the system ? I have rads with autoimmune vents in them , will this be enough to clear the air
Thanks
Hi All
I am fitting a larger radiator and need to fill in the chase at each end of the radiator approx 25cm each end, I have some easifill 60 to fill the chase about 50mm deep.
How long will it take to be able to sand and paint. I need it asap as the plumber can then come back and attach the...
I am having a rad changed this week for a larger rad, I have a system boiler and a tank in the airing cupboard. My question is when the plumber drains the rads will I lose all of the hot water in the hot water tank or will it only drain the heat side of the system.
Many Thanks
Hi All
I have 2 tall rads in the kitchen thats only getting tepid, I have tried to balance the system and can get the 2 rads hot but when I open up the rest of the rads the 2 tall ones go tepid again, I have a Vailant Ecotec 615 plus with 13 rads. I had the pump in the boiler replaced about 2...
Had the en-suite retiled last year but one tile now shows scratches on the tile , if I rub it to clean it , it seems to go but comes back , any way of getting rid completely
thanks
Hi All
I have a Vaillant eco tec 615 plus boiler sealed system with a tank In the airing cupboard managed by a Hive thermostat and intermittently the hot water is cold when having a shower at 8pm ish. The times to heat the water are 0600-0700 1100-1130 and 1700 -1830 and it always worked ok...
Hi All
Ive had a new worktop and sink fitted but the worktop sticks out too far , much further than the original and the fitter said its because we have had a granite sink fitted and it needs more support. Is there any difference in fitting a granite or composite ? and any idea on the cost to...
HI All
my cistern valve is sometimes leaking into the pan, its a https://www.screwfix.com/p/viva-button-handle-dual-flush-valve/6998h
I have cleaned out the cistern so as nothing is stuck under the valve , does this mean the valve needs replacing.
Thanks
Hi All.
Happy new year.
I have a Vaillant ecotec plus 615 system boiler with tank and the hot water isn't getting hot sometimes , we notice at night when having a shower. it is set to heat water 5am-6:30 11-12 and 6pm till 7:30.
I have checked the boiler when it's heating the water and the...
Hive system been working ok for a while but the last 2 days the hot water has been cold at 8pm for a shower even though the hot water schedule should have heated it up for 6pm to 7pm. Everything else seems ok. So apart from a factory reset and reprogram is there anything else I can do please.
Thanks
Hi All
I have 3 casement window all letting a draught in at the same place, the windows are 12 months old but cannot get the installers back. Can you advise how to adjust the window to seal the draught please. The side that is draughty isn't the one with the middle post attached.
Thanks
Hi All
I have a toilet seat I wish to replace as the chrome fittings are peeling and looking awful but its a soft close with hidden fittings and I dint know how to take it off ,
photo attached
Many Thanks