Search results

  1. B

    Glowworm back boiler, Inset BBU 40 or 50.

    Glowworm back boiler, Inset BBU 40 or 50. Keeps cutting out red light comes on. Plumber said it was the coil in the tank not circulating. But the tank does circulate, it has been de-scaled. Old council house, All radiator pipes come from upstairs, If I run the water out of one downstairs...
  2. B

    Building/Laying concrete over sewage pipes.

    A friend wants to build a garage, There are two sewage manhole cover's in garden, Both look to enter one another then run off together out of property. Not storm drains, And not showing on water board plans. Are there any rule's, law's or local planning regulations for adding a concrete...
  3. B

    Lifestyle LP214 programmer / timer with RTS 1 thermostat.

    Heating / Thermostat messed up, All has been taken out and wired again, Think it has been wired incorrectly by ME, HEHE. Thermostat Turns Heating Pump on only. I have wired through LP214 and straight to pump, if i wire to pump works, If i wire to LP214 it does not work at all. Wired LP214...
  4. B

    Gas Back Boiler Timer thermostat help.

    My mams thermostat went off. So we bought a new one. This one has 3 wires connected instead of two like the old one. All wires were in the back of the timer, I have taken the the wires out and put them in a junction box and followed instructions. The thermostat now only turns the central...
  5. B

    Painting inside smooth concrete garage damp walls

    I want to spray paint the inside of my concrete sectional garage walls but the walls are very smooth and damp, Is there any special precautions i need to take? I will be using some white floor paint i bought and mixing it with cellulose thinners.
  6. B

    Electric to Outside Pre-Fab Garage,

    I want to connect some electric to inside garage, I have had all the work done, Plastic yellow pipe about 4 inches round under floor in house and under garage base then under block paving outside garage at least 50cm deep. Can i use noraml 16MM twin and earth cable??? From inside/house consumer...
  7. B

    External Wall Resin or similar.

    I am looking to paint the walls of my house with some kind of resin or similar, i have my own compressor and want to spray it on i can buy a different spray gun if need, be. The only thing is i can not find any suppliers of this or similar paint for walls, I want to cover the breaks up so you...
  8. B

    Air conditioning and electric overhead wires/cables.

    I am fitting and air conditioning metal unit to the side of my house, I have three overhead cables coming in at the side, the outdoor unit will be about 75 cm, 30 inches away from these wires. These wires are covered in plastic looks like Live and neutral the earth is bare wire, will it be ok to...
  9. B

    ADE Alarm panal adding 2 bellboxes

    i have installed a ADE accenta mini g3 alarm, works great but i want to add an extra bellbox to the back of the house. The font bellbox is a ADE response 8, the back one is unknow make/model, white with blue border for 360 degree strobing. on the circuit board it has +12 volts, 0v,tam 0v, neg...
  10. B

    Tripping RCD and MCB

    My downstairs sockets have just tripped out today, i was outside using the drill and the electric went off. I turned the rcd back on but it will not stay on as soon as i turn it on it just goes off. So i unplugged the downstairs socket wire on the mcb and moved it over to none rcd protected side...
  11. B

    WYLEX RCD 63A 30mA.

    I am buying a new consumer unit for a qualified electrician (Part P) to fit, Is a WYLEX RCD 63A 30mA. Ok to buy to connect to a 9.5KW shower, already installed, With 10mm cable 15 meters? It goes up a plasterboard wall then acroos the loft to bathroom, i have to buy all mcb's/ rcd's seperate for...
  12. B

    Garage alarm help with wiring.

    I have two problems with a new alarm system, First is with a CQR Bellbox, It's old with no instructions, Siren is not connected to circuit board and no strobe, i need to connect six wires to circuit board and six to a melcom 600 alarm panel, Alarm circuit board has RET-, SW- 4-,3+, +v2,-V1, Any...
  13. B

    Ring Main Spur, Socket not working,

    I have added some Cheap sockets to my ring main, Double socket above double socket so instead of two plug holes now have four plug holes. Two wires twin and earth 2.5mm in original socket with one twin and earth 2.5 mm going to the new socket . Only thing is only one plug hole works on the spur...
  14. B

    Optima XM6 Engineers Manual

    My brother-in-law has moved into a new house, Owner passed away, the alarm has the fuse removed and battery unplugged, When plugged in can clear alarm using 0123, can not get keyfobs working and need to set zones back up and disable unused, I have manual for new G3 alarm. Has any one got this...
  15. B

    Garden Electric supply.

    25049 3C1.5 XLPE/SWA/PVC i have just ordered this from screwfix for the garden. Probs going fivteen meters to decking. Will it be fine to take a spare of a norml plug socket. or does the armored cable need to go to consumer unit about twenty meters away. Sockets could be used for 3KW pool...
  16. B

    Gloworm 30CXI Not Lighting

    Hello there. I took the flow switch out of the boiler and then put back in now the boiler will not light at all for heating or water. Have checked fuses, wiring and so on. Can see gas lights inside but then boiler shuts gas off and tries to light again. error message F1. Was fine before i took...
  17. B

    GLOWWORM 30CXI PROBLEM

    Boiler does not heat hot water anymore. I get an error message of F9. I have powered off on checked pressure. Heating works fine. Can hear a popping noise as well inside boiler. Hot water gets warm for two seconds then goes cold then warm and so on please help. Thanks.
Back
Top