Search results

what do you mean tee'd off the other rad in dining room? is it not feed from the main pipes running from the boiler?

this is the worst one, the rest are tiny and closer to the wood than this, i dont think there is a problem but i asked just to be sure, btw the gaffer tape is my masking tape for painting! lol was to hand at the time :D

i have noticed hairline cracks around the wooden supports in my newly built and plastered kitchen vaulted ceiling, i take it this is the roof settling now its all finished, around the velux windows its fine, should i wait a while to check movement and then paint over the cracks at a later date...

bazinga!

spark contacted, work done, signed off, happy days :D thx to all who contributed useful info

just a post to say thanks to all who contributed info, went for the professional tradesman approach, jigged the bank acc/bills and found enough, they did a spot on job, but thx again to all for contributions.

the oven doesnt have any vents on the top, i take it that its unvented, its a new pyrolitic oven, i checked the zanussi website on their induction hobs and it seems they can be fitted above ovens as long as you make sure the front bar in the wooden housing is removed and there is more than...

i know this topic has a few questions already but they seem to date back to 2009, 5 years on and i was wondering if fitting an induction hob over an oven is do able nowadays, wickes designed my kitchen and they put the hob over the oven, nothing was mentioned about the possibility of the hob...

boiler man said both could go in to the soil stack, wickes sell a 22mm condense strap boss adapter which means condense and ch drain can be put straight into soil via a strap boss, obviously 1 strap boss each! lol thought i better say this it saves mass confusion with replies, btw prv pipework...

new kitchen, from the ground up, demolished a 3x3 kitchen now got a new bigger extension, new kitchen, downstairs loo added, incl a new ch system and nearly finished! woo hoo! the next 2 weeks gonna be busy

if it cant be properly 'trapped' Dan then i will run it to outside, if it aint right it aint being fitted, spent too much to cut corners at the end :|

thanks for that tony

i wish people would actually read the op, jackrae, copper condense? where did you read that? anyway nice reply dan_robinson, ':roll:' all we can expect from you? anyway back to the adults, thx for the help picasso will run the ch drain to outside and will put the PLASTIC condense drain to...

hello, is there a fitting that can be used to go from condense drain pipe straight to standard soil pipe ? also can i fit a 22mm copper pipe straight to a soil pipe? the boiler is right above the soil pipe and instead of running the condense to outside i want to run it inside to the soil pipe...

Thanks jeds, just to be on the safe side gonna put in some braces, had a roofer take a look and he said even though the ridge installed looks OK he would install some if it was his place, so I'm gonna install a couple and make a feature of them, thanks for your help jeds.

hi jeds, thx for the reply what do you mean by collared?do you mean fitting a beam a third up from the wall going from 1 side to the other? the roof has a gable end, the rafters have a ridge beam running front to back, do you mean doubled up underneath the one in place already? the joists...

hello all, i have had a kitchen built, block outside and timber frame inside, how big can you go before the roof needs a brace in the middle to stop spread? the ext is 5m x 5m ext size, but the kitchen area is 3.7m along 1 side because i have a timber framed wall going to the middle of the ext...

hi people, i have a new 5m wall which needs rendering to match existing house, cant afford to get anyone in to do it so any advice about starting it will be much needed. im going to break it up into smaller sections with beading to make it easier to manage, i have been reading that i need to...