Search results

Morning everyone need some advice if possible please. New system boiler installed by a company. boiler on the ground floor and mega flow. Pressure of hot and cold fine ground floor and first floor but loft has dropped from 8l per min to 3per min on hot and cold. 22mm hot goes to the first floor...

Thanks for that really detailed answer and helps a lot to understand. Would there be anything I can do help increase the pressure to then get a better flow rate for hot and cold in the loft taps and bath

Yes that blue pipe is for the house was extended to the cylinder. I can a gauge and I can do the testing. If the pressure at the mains is low how would that be that the both floors have a decent flow rate but the loft don’t? It’s really weird how they didn’t install a gauge

The only thing they said to have done was extended the blue pipe to were the cylinder now is and changed the route slightly of the hot and cold downstairs. Everything else was as it was before. How the flow is considerably low. Is there anything I can do to test the pressure and then I can say...

I’m not sure as the main dynamic pressure. But middle floor taps and bath taps are about 12l and upstairs is really considerably low. They are saying that it’s nothing that they have done. I’ve explained to them that the pressure just can’t just miraculously go down that much. They also...

Is there anything you would recommend to fix ?

New unvented system fitted however all the taps on the ground floor and middle floor have 12l per min but in the loft is 4L. A considerable drop to what was before around 8L per min. Any ideas what can be done to cause this drop and what can I do to improve the flow rate. Really appreciate it

Got a call running bath tap turned up to this job Someone has been trying to remove it before I got there .. typical. Any tips to remove this tried some brute force and wd40 but it’s not budging. Would it be easier to just remove the whole tap

Cheers mate I’ll pick that up tomorrow and sort that out

Yeah I meant it deteriorated I’ll just get a 32mm basin un slotted waste that should do that job isn’t it Comes with new washers and sealing nut

That seal is totally gone had a look. Could I not get a normal basin waste like the one below and just replace it for that.

Leak coming from the yellow circled on the picture. It seems too big and it doesn’t secure fully causing water to seep through. What could I get to replace it ? it’s not your normal Basin fitting

Mate you were spot on! Nice one for that all sorted

Can’t get these toilet seats fittings out to replace it for a new one. It’s like they are rusted away. Cusomer has tried to take the on the right off but it is not budging. Any tips or ideas ?

Thanks will go and get that!

Can I just buy the seal or would changing the whole unit do the job?

Have a leak coming from the black part under the bath. Drips down onto the floor. Is that the overflow and is it universal? Can’t seem to find anything similar And is it quite easy to fix haven’t changed one before

Got a slight drip with the shower head on this shower. Replaced the washer and the head. But no luck still dripping. What can I do to stop this ?

So an update on this. I managed to get to the nut on the flush pipe and add ptfe and some plumbers mate and tried but no luck. Still leaking by the looks of it from the flush valve nut. It’s a corner toilet in a really small bathroom can’t get any access to that nut. Want to take the cistern...

well I’m getting there slowly. Newish really about a year or so. Don’t have much on my van yet