Search results

this is not the worst one but most of my other windows are sealed all the way round with no gaps at all

they are in the bit i pictured but in some some of the corners on the under side of the plinth there is big holes where it has never been sealed

Hi, could someone give me a link as to where to buy this kind of sealant around the outside of my windows, every where i go they just try selling me normal silicone but its more of a mastic than silicone.

I thought that might be the case, on having another look there is a t shaped channel all the around the window so I'm thinking I might be able to remove the seal that's is there and find one to fit into this channel i have ordered one of them seal kits so going to see if any fit in the gap...

Hi, I've got a window which is around 12 years old with a damaged seal, thought they would just be push in types but it looks like it is stick on or bonded, I've tried searching but cannot find seals like it, looks like a flipper seal and the part that is stuck to the window is very small, can...

I have fitted a sheet of WBP 18mm ply to my shower base does this need priming with anything before I put my cement mix down? If so, would this stuff be any good that i primed my floor with before screeding it...

Good afternoon, I am currently finishing building a shower tray base to hold a 1700 x 700 stone resin shower tray as in the picture, my query is what is the best was to be able to still get access to the waste trap and pipe work should I need to. The base is going down onto a concreate floor...

I am ripping my bathroom out to fit a new one, the property was a new build 11 years ago since i bought it, I've never had any issues of loose tiles etc but when i came to remove the tiles they just dropped of like they was not even bonded, one full wall came crashing down with a few hits of the...

The cable does come down the wall vertically and it also runs off to the right hand side at the top of the plaster board to the next light fitting as I've been up with my enderscope to have a look at the routing so no need to extend cable will just end up with some slack in the cable as the...

Hi all, little question i want to move the shaver socket in my bathroom 10cm to the right to allow for a bigger mirror, the socket will be at the same height and will be further away from the sink area and sources of water, is this notifiable work? as there is no alterations been made to wiring...

Hi all, I need a bit of advice on the use of wedi boards as I've never used the stuff but it looks a great product to create my wet room with, the fitting of the boards and sealing seems straight forward my issue is when it comes to fitting towel rails etc once the tiles are on. Can i just...