tamper problem

  1. J

    ADT Visonic Powermax 10 tamper fault clearing

    Hi. I wonder if anyone can help me please. My daughter has moved into a house with an ADT Visonic Powermax10 wireless alarm. My daughter wanted to avoid the cost of an ADT contract and their call out charges that are quite high. The door sensor (looks like a PG9975 or similar) was reporting...
  2. R

    Pyronix Enforcer PIR - lost back plate for tamper alert

    Hi everyone, I am currently getting some renovations done to my house so the builders took down the PIR sensors. Since then I get constant errors on tampers etc so I haven't been able to use it. They are now ready to put it all back again but have managed to lose the back plate on one of the...
  3. P

    Scantronic Burglar Alarm - How to Clear a Tamper

    After a power cut today my Scantronic 9427 panel 'Tamper' light is on. How can I clear it and make the alarm usable again? I have attempted to implement the factory reset process described on page 10 of the closest I can find to my panel, which is available on line here...
  4. R

    Accenta G3 not arming

    Hi there, I have an Accenta G3 alarm that makes all the right noises to set but then does not activate when I try and set it off. There are no errors showing on the keypad. There are 3 PIR sensors connected and i have completed the walkthrough in Engineer Program Mode and they all work...
  5. S

    Pyronix Enforcer random tamper alarm (when unset)

    Hi folks, The house I've lived in for a year has a Pyronix Enforcer 10 and during the last week it has sounded when unset at random times. Last Thursday it went off twice in the evening, showing a tamper with areas A, B and C all affected. After a quiet weekend, it has gone off 6 times in the...
  6. J

    Pyronix Enforcer ENF32GB - Going Off

    Hi all, I installed this in 2016 and only recently has the alarm been going off during random hours of the night when set. I have attached a picture to show the issue. I have tested the signal strength and the signal is very good for all devices paired, I had done a system test and all is...
  7. S

    Agility 3 - Tamper Alarm

    Hi Everybody, Hope one of you peeps will be able to help? We have the Risco Agility 3 installed. The batteries for the Wireless Keypad ran out so i called the installer who quoted £90 call out plus £65 for batteries. I thought that was a little steep and the guy said i could change them...
  8. D

    Gardtec 350 tamper problem

    Hi All, I have just moved into a house with a Gardtec 350 alarm system, and am trying to see if it is functional. It has four detectors and a panic button. The battery is flat, so I've got another one on it's way. There seems to be a problem with the tamper system, as the Tamper LED is...
Top