I am in the middle of fitting a new bathroom. The current waste pipe for the bath is 35mm copper, which I know is below the minimum requirement...
So I generate small volumes of trade waste, boiler parts, packaging and the usual junk that goes with the territory for being a boiler man. Have...
So as I've mentioned here, I'm currently planning a Garden Office build at the end of our 30m garden. The building will contain a small...
How do I replace and fix this? The base trim in my basement bathroom was soft them molded, clearly it wasn’t typical moisture. I demolished the...
Hi all, new poster here and hoping for some advice. We have a manhole that blocks occasionally, so i periodically clear it to prevent that. When...
Hi all, Looking to install a small washroom in the first floor of my house. There is a single bathroom on the ground floor of the property...
I've been looking online at a new sink base unit that's listed as having a 40mm void to it's rear? Is it 40mm, or is it actually larger in order...
It's been many years since I last sorted a bathroom but, sadly, the bullet must be bitten. Obviously, in the interim it's been realised that the...
I’ve seen various videos showing how to fit a new pop up waste – and I'm now realising that this is often done BEFORE the sink and pedestal are...
I'm looking to install a macerator in an underground room. I need to pump the waste up to a 4" soil pipe at ceiling level but, because of ceiling...
The waste pipe on this tumble dryer is especially small diameter. No problem as it comes with an adapter which you put into the compression...
Hi I'm not much of a diy expert particularly on drainage. Had this drawing done a few months ago and now I have a waste for sink from plumber and...
Hi - I am installing new kitchen and changing position of sink. Access to soil pipe is 3m from sink and will run behind units with one 90 degree...
Hi all, We have a downstairs bathroom with toilet, basin and shower. The toilet is fitted with a Durgo valve. The downstairs bathroom is an...
Hi, under my bath is a waste pipe, with a 15mm pipe going into it, the gap is blocked with lots of silicone, but it seems to be leaking a bit !...
Planning a new bathroom, can anyone see any issues with this waste water design? I plan on using 50mm solvent weld pipe and can achieve the...
Hi guys, just after some experienced opinions if you don't mind? We're doing our bathroom at the moment and we've had to move the toilet, so in...
I have installed a Grohe Talentofill (28991000) now need to connect the waste. As usual the waste now poses a problem. It appears that the...
Hi, Sorry if this is obvious, but I have read the Wiki and the FAQ and can't find an answer. The last trap (there are two after the pipe) at the...
Our bathroom basin sink just refused yesterday morning to drain away. After pulling apart all the units I managed to get to the trap, cleaned...
Separate names with a comma.
Visiting from the US? Why not try DIYnot.US instead? Click here to continue to DIYnot.US.Dismiss Notice
