I assume you mean for the mitres, Mark your cut line down the face then on the thick edge9opposite to the molding mark your 45 hold your squre along this line and use it as aguide for your saw cut down as far as you can using the squaree as a guide and after that carefully cut down the face line being careful to keep to the 45 degree angle a block plane can sort out any minor discrepancies.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local