- Joined
- 25 Apr 2018
- Messages
- 22
- Reaction score
- 0
- Country
Hi,
I'm ew to the forum, so please bear with me.
I did a self install on a wireless Pyronix Enforcer system and to be honest its working great. However I want to drive a Klaxon from one of the wired outputs from the board below, which came installed in the main Enforcer panel.
The Master Blaster Klaxon has a 12VDC interface relay (which draws around 35milliamps) which when activated then pulls in the 240VAC supply to power the Klaxon.
So my questions are...
1) Can I drive the the Kalxon interface relay from the BELL output on this unit?
2) If I can do (1) above how is it wired? I am thinking I take a pair of wires and connect these to the +12VDC terminal and the BELL terminal in the Enforcer panel and connect to the relay. Is this correct?
3) Do I need EOL or Tamper resistors with this set up? If so what values and where do I connect them. The Klaxon does not have any Tamper connections so if I need to connect resistors I would do it in the Enforcer panel
4) I am assuming from the I/O board specifications above the bell circuit will drive unto 250 milliamps.
Sorry its a bit long winded, and thanks in advance for all answers.
regards
Mark
I'm ew to the forum, so please bear with me.
I did a self install on a wireless Pyronix Enforcer system and to be honest its working great. However I want to drive a Klaxon from one of the wired outputs from the board below, which came installed in the main Enforcer panel.
The Master Blaster Klaxon has a 12VDC interface relay (which draws around 35milliamps) which when activated then pulls in the 240VAC supply to power the Klaxon.
So my questions are...
1) Can I drive the the Kalxon interface relay from the BELL output on this unit?
2) If I can do (1) above how is it wired? I am thinking I take a pair of wires and connect these to the +12VDC terminal and the BELL terminal in the Enforcer panel and connect to the relay. Is this correct?
3) Do I need EOL or Tamper resistors with this set up? If so what values and where do I connect them. The Klaxon does not have any Tamper connections so if I need to connect resistors I would do it in the Enforcer panel
4) I am assuming from the I/O board specifications above the bell circuit will drive unto 250 milliamps.
Sorry its a bit long winded, and thanks in advance for all answers.
regards
Mark