My dishwasher is showing error 4 flashing lights.
This I understand from previous posts is a drainage problem.
I cleaned filters and inspected pressure switch all ok. I emptied hot water into the m/c and ran same. The water drained away ok.
I then selected a program and ran m/c. After approx 5 mins error re appeared!
I think the m/c may not be filling up with water. Therefore the m/c does not have water to pump out which is bringing on the error!
I have disconnected water supply to verify same and there is plenty of supply there!
Any ideas????
This I understand from previous posts is a drainage problem.
I cleaned filters and inspected pressure switch all ok. I emptied hot water into the m/c and ran same. The water drained away ok.
I then selected a program and ran m/c. After approx 5 mins error re appeared!
I think the m/c may not be filling up with water. Therefore the m/c does not have water to pump out which is bringing on the error!
I have disconnected water supply to verify same and there is plenty of supply there!
Any ideas????