Ive recently carried out some internal work and had to remove a wired
sensor from the wall in order to board and plaster it. Today I re-fitted the sensor but the alarm wont turn on and wondered if anyone could offer any advice.
After replacing the sensor the alarm wouldn't turn on and the tamper light was flashing (not location light) so we entered the pass-code and pressed the reset button and everything seemed OK. Tried to turn the alarm on earlier but it still wont come on.
Any ideas?
EDIT: The alarm is a Veritas R8
sensor from the wall in order to board and plaster it. Today I re-fitted the sensor but the alarm wont turn on and wondered if anyone could offer any advice.
After replacing the sensor the alarm wouldn't turn on and the tamper light was flashing (not location light) so we entered the pass-code and pressed the reset button and everything seemed OK. Tried to turn the alarm on earlier but it still wont come on.
Any ideas?
EDIT: The alarm is a Veritas R8