Anyone recognise these?

[mikeyme]

I have some kitchen sink taps to replace and don't recognise these connectors, any tips for removing them? Would be nice if I could find one not assembled before I remove them to understand how there fixed?

Just in case the image is not clear, its copper to copper piping. Looks like some type of push fit?

Any help is appreciated, thanks.

 

[doitall]

Take the white caps off and all should be revealed

 

[ChrisR]

..then check "Speedfit"
There will be a collar/sleeve near the copper which you push in, to enable the pipe to be pulled out.

 

[mikeyme]

Cheers, that sounds good. I figure the white parts were just caps.

So I pop the white caps off and its like a regular push fit unit from there on in?

 

[mysteryman]

I don't think these are Speedfits. See if the white parts unscrew from the yellow parts. You may be able to dismantle and reassemble them. Or you can cut-and-shut.

 

[ChrisR]

Could be right, there were some icky ones.

 

[mickyg]

i come across some like this a while ago and had to hacksaw them off