My heating system has a Flamco Flexvent automatic air vent in the primary circuit to the HW cylinder, immediately after the mid-pos valve.
The valve has started to leak from just below the red button on the top - large damp patch on the airing cupboard floor.
I suspect that dirt has got in and is stopping the valve closing. The vlave seems to be in two parts and, according to the Flamco website you can remove the top half for cleaning.
Has anyone ever done this? If not how else do I solve the leak problem?
Thanks
Flamco also say that there are two washers below the red button which should swell up to prevent water leaking!
The valve has started to leak from just below the red button on the top - large damp patch on the airing cupboard floor.
I suspect that dirt has got in and is stopping the valve closing. The vlave seems to be in two parts and, according to the Flamco website you can remove the top half for cleaning.
Has anyone ever done this? If not how else do I solve the leak problem?
Thanks
Flamco also say that there are two washers below the red button which should swell up to prevent water leaking!