One of the bath taps broke so just had to buy a new set. After finally removing the old tap which was a struggle, I noticed the bath tap had some sort of clay type compound all over the thread and inside the square indent in the ceramic bath. I'm guessing the square indents were to stop taps spinning?
Anyway the new taps washer don't quite cover the square so water will flow down the tap hole
Any suggestions what I should use to either build up the square indent so I can use the washer or is there away without using the washer?
Anyway the new taps washer don't quite cover the square so water will flow down the tap hole
Any suggestions what I should use to either build up the square indent so I can use the washer or is there away without using the washer?