Hi, My Beko Washing Machine wont complete it cycle and just crashes half way through, I have checked the following....
Pump is clear and all pipes
The washing machine is ok when filling with water
The problem sems to arise when it come to spin.
The bushes are fine and I have checked them (20mm)
I have reset the machine up-teen times and althoug it does reset, the problem stays.
I have suspected the door catch, does this sound familiar?
-just exploring another avenue here, does anyone know where the load sensor is for this washing machine, I have been told that the washing machine will not spin if it doesnt have enough weight in the drum, I suspect that this also could be the problem.
Also, the drive belt from the motor is in good condition, so that has been ruled out,
Thanks Stef
Pump is clear and all pipes
The washing machine is ok when filling with water
The problem sems to arise when it come to spin.
The bushes are fine and I have checked them (20mm)
I have reset the machine up-teen times and althoug it does reset, the problem stays.
I have suspected the door catch, does this sound familiar?
-just exploring another avenue here, does anyone know where the load sensor is for this washing machine, I have been told that the washing machine will not spin if it doesnt have enough weight in the drum, I suspect that this also could be the problem.
Also, the drive belt from the motor is in good condition, so that has been ruled out,
Thanks Stef