I recently plastered a friends kitchen. It was over extremely thick artex so took a few coats. It appears that he's painted them before the plaster has fully dried so the paint blistered and flaked. He then pva'd the wall and tried again. Again blistering.
Q1. Is there an easy solution as in magic stuff to paint on to sort it out. OR
Q2. Is it possible to overskim again and then follow the correct procedure when the plaster dries. If this is ok do you still pva the wall.
ps only one wall has the blistering
+++++
I have deleted your duplicate post.
Mod Rupert
+++++
Q1. Is there an easy solution as in magic stuff to paint on to sort it out. OR
Q2. Is it possible to overskim again and then follow the correct procedure when the plaster dries. If this is ok do you still pva the wall.
ps only one wall has the blistering
+++++
I have deleted your duplicate post.
Mod Rupert
+++++